The FT8 thread should match the number of logical cores of the CPU, not AUTO. If you have a problem, try -1 or -2 logical cores.
For 〓〓〓〓〓〓〓〓 〓〓〓〓〓〓, select 2. If you are using a high performance CPU, 3 is also fine.
Select high for 〓〓〓 〓〓 〓〓〓〓 〓〓〓〓〓〓〓〓〓〓〓.
For 〓〓〓〓〓〓〓 〓〓〓〓〓〓〓〓〓〓〓, select use subpass.
Put a check mark in 〓〓〓〓〓〓〓〓 〓〓 〓〓〓〓 〓〓〓〓〓〓.
If you find that the decoding is too slow with these settings and the Lag value is actually too high, try changing the decoding cycles value and decoder sensitivity to use low thresholds to see what works best.
An upper limit of 3100 for the wide graph is sufficient. It is unlikely that any station will come out above that. It is not recommended to use a value smaller than 3000, because only the range shown in the wide graph will be decoded.
ｺﾒﾝﾄをする